The L298N motor driver actually has two input power pins VS and VSS. ![]() Remove the jumper if the supply is greater than 12V. The L298N motor driver module is powered through 3-pin 3.5mm-pitch screw terminal. It can be easily connected to any microcontroller or Arduino board, making it perfect for DIY projects. There is also an onboard 5V regulator – so if you’re using between 7 and 12V DC to driver the motors, the module can supply your microcontroller with 5V DC. This motor driver module is versatile and easy to use. Enable signal input voltage range : Low: -0.3 Vin 1.5V (control signal is invalid). Control signal input voltage range : Low: -0.3V Vin 1.5V. For now, I have simplified the setup and the code to the basics to try to get it to work. As you know, any L298N module has the ability to drive two motors at once, but you may not know that one instance of the library is intended to pilot only. Driver: L298N Dual H Bridge DC Motor Driver. The RPM is controlled using PWM input to ENA or ENB pins, while of rotation direction is controlled by supplying high and low signal to EN1-EN2 for the first motor or EN3-EN4 for second motor. Asked 3 years, 5 months ago Modified 2 years, 5 months ago Viewed 6k times 2 I am trying to get the L298N to work with a simple DC motor. L298N Dual Motor Controller can control both motor RPM and direction of rotation. The L298 is an integrated monolithic circuit in a 15-lead Multiwatt and PowerSO20 packages. The driver has a nice heatsink to keep the L298N cool and all driver lines are diode protected from back EMF. ![]() L298N Dual Motor Controller is based on the L298N heavy-duty dual H-bridge controller, which can be used to drive two DC motors at up to 2A each, with a voltage between 5 and 35V DC.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |